If optional in the BIOS, increase the TDP limits of the processor to 250 Watts (by that you are allowing a higher power draw), most motherboards have this pre-configured pretty okay these days though.

Leave base clock (bus) for what it is right now.The generic overclock procedure for multiplier based overclocking is as follows: The true Guru3D audience overclocks from the BIOS and tries to find the maximum stable limit.

We tried both Multiplier and BLCK tweaking, both resulting in similar conditions. And yes, we re-seated the cooler a couple of times and did swap out TIM as well. However at that stage we are touching 100 Degrees C on the CPU. We needed a massive 1.350~1.375 Voltage range to reach 4.4 GHz (which is an awful lot for a 14 nm processor). During our measurements by trial and error we found that at 1.3 Volts you will end up at roughly ~4.2 GHz. The 6950X has a base clock of 3.0 GHz and may boost to 3.5 GHz. Obviously overclocking 10-cores is a tough job. As I am about to show you even this cooler is not capable enough. So, as you can see we are using liquid cooling already, a Corsair 110i GT, which is a pretty good AIO cooler TBH. In our initial experiences we concluded that the CPU cannot take high voltages (which are required to reach higher frequencies). The results however remained 100% the same, it seems we have a very bad sample for overclocking, or high temperatures once you pass 4.2 GHz / 1.30 Volts is just the nature of 14 nm Broadwell-E. The temps actually went up so fast that we doubted it was the processor and started doubting the motherboard or its BIOS. Your voltage should sit at maximum at roughly up-to 1.325 Volts with an AIO water-cooling, dual rad minimum seriously recommended! Overclocking with Broadwell-E is far more difficult than we expected it to be (at least once you pass a frequency threshold). Also get yourself a good power supply and proper processor cooling. First tip, always invest in good hardware by the way (MOBO / PSU / Memory / Cooling), the cheaper motherboards often are not well tuned for enthusiast overclocking. We're keeping it relatively simple. We need to take a couple of steps if we want to overclock. With so much horsepower in the system we could not resist trying out overclocking. Tweet Overclocking - The Core i7-6950X On X99

Download asus rampage v edition 10